Touch Dimmer mini Project

TOUCH DIMMER

By simply touching this touch dimmer you can increase the light intensity of incandescent lamps in three steps. The touch dimmer is built around 8-pin CMOS IC TT8486A/TT6061A specifically manufactured for touch dimmer

applications. Initially, when mains switch is ‘on,’ the bulb is ‘off’. Now, if you touch the touch plate, the bulb glows dimly. On

second touch, the bulb gives medium light.At the third touch, the bulb is driven fully. Another touch puts off the light.

Since the IC is highly sensitive, use along wire to connect the IC to the touchsensor. The circuit uses minimum external

components. For touch plate, you canuse a simple copper plate of 1cm×1cm oreven the end of the lead wire. Touch plate is coupled to the touch detector through 820pF, 2kV capacitors C1, C2, and C3 connected in series. Internally IC TT6061A’s

touch signal is connected to the counter/decoder via a resistor and clock input CK is connected to the counter/decoder via frequency generator. Line frequency signal is taken through R4 at pin 2 of IC TT6061A. At zero crossing,

the triac (BT136) triggers to drive a 200W bulb.The 6.8V power supply is taken directly from mains through resistors R1 and

R3, diode D3, capacitor C4, and zenerdiode and fed to power-input pin 3 of the IC. Capacitors C1, C2, and C3 connected

between touch input pin 4 and touch plate remove the shock potential from the touch plate, so do not replace these capacitors with a single capacitor or with a capacitor of a lower voltage rating. Mains potential exists in the circuit. Needless to say, it is dangerous to touch the circuit when mains is ‘on.’

for download